Printronix ThermaLine Series Printer User Manual


 
8–23Error Codes
Multinational Character Set Errors
150 ISET character selection parameter n error – 00 to 31
An ISET character set selection parameter value between 0 and 31 was
expected. Error was caused possibly by an invalid numeric value or an alpha
character.
151 USET decimal input error in input parameter
The USET command was expecting a decimal parameter and either received
none or received an alpha character.
152 USET character set n parameter error
A USET character set selection parameter value between 1 and 8 was
expected. Error was caused possibly by an invalid numeric value or an alpha
character.
153 USET substituted character illegal – must be 1 of 16
During character substitution in the USET command, the hex value for the
character being replaced must be one of the specified 16 hex values. Only the
following hex values (Ca) can be replaced by another hex value (Fa): 21, 22,
23, 24, 25, 26, 40, 5B, 5C, 5D, 5E, 60, 7B, 7C, 7D, 7E.
154 USET defined character illegal – must be hex 20–FF
During the USET command, the hex value for the substituted character (Fa)
must range between 20 and FF hex. The value given may be out of bounds.
155 USET syntax error – END command is expected
An END command is expected when the USET character set definition is
completed.
156 No such CONFIGuration option
157 Left or Top/Bottom margin too large for the current page size.
158–159 Not defined.