Psion Teklogix 7530 G2 Laptop User Manual


 
Chapter 5: Configuration
Decoded (Internal) Scanners
160 Psion Teklogix 7530 G2 Hand-Held Computer User Manual
5.11.3.4 Decoded (Internal) Data Options
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single
character prefix already selected, the code ID character is inserted between the
prefix and the decoded symbol.
When you double-tap on this parameter, a dialog box is displayed in which you can
choose a transmit code: None, AIM or Symbol.
Scan Data Format
This parameter allows you to change the scan data transmission format.
Double-tapping on “Scan Data Format” displays the following options from which
you can choose a data format: data (as-is), data [S1], data [S2], data [S1][S2],
[P] data, [P] data [S1], [P] data [S2] and [P] data [S1][S2].
Prefix [P], Suffix [S1] And Suffix [S2]
A prefix and/or one or two suffixes may be appended to scan data for use in
data editing.
When you double-tap on these parameters, a dialog box is displayed in which you
can enter a value from
0 to 255.
Delete Char Set ECIs (
SE2223 only)
Setting this parameter to on enables the scanner to delete any escape sequences
representing Character Set ECIs – Extended Channel Interpretations (also known as
GLIs) from its buffer before transmission.
When this parameter is enabled, the scanner transmits data from PDF417 and
MicroPDF417 bar codes containing Character Set ECIs, even when the ECI
Protocol is disabled.
ECI Decoder (
SE2223 only)
Setting this parameter to on enables the scanner to interpret any Extended Channel
Interpretations (ECIs) supported by the scanner. This parameter has no effect on
symbols that were not encoded using ECIs.
If this parameter is set to
off and a symbol that was encoded using an ECI escape is
scanned, the scanner transmits the ECI escape followed by the uninterpreted data.