Q-Logic 9000 Network Cables User Manual


 
2 – Operations and Administration
D000003-006 Rev. A 2-11
Q
2. Select the radio button of the spine(s) to be rebooted, or select the Reboot
Entire Hemisphere radio button to reboot the applicable hemisphere and all
spines.
3. Click Reboot.
2.1.4.2.3
Rebooting Multiple Managed Spines using the CLI
In a redundant management configuration (9080, 9120 and 9240) it may
occasionally be necessary for the user to reboot both managed spines in a
hemisphere. This is accomplished through the CLI of the master spine.
1. Access the master spine CLI via Telnet, SSH, or through the switch RS232
serial ports.
2. The system prompts for a user name. At the prompt enter:
admin
3. The system prompts for a password. At the prompt enter:
adminpass
The system responds with:
Welcome to the <SWITCH> CLI. Type 'list' for the list of
commands.
4. To reboot multiple spines enter the following command:
reboot now -m -n
where:
now initiates the reboot process as soon as the user presses Enter (i.e., no
system y/n prompt).
-m reboots just the management card of the master spine. This is a
non-disruptive reboot (i.e., the reboot will not interfere with any switch traffic).
-n reboots just the management card of the slave spine (in a non-disruptive
manner).
NOTE: If accessing the CLI through Telnet or SSH, the user will need to reconnect
to the CLI following the reboot.
2.1.4.3
Chassis View Component Information Area Tabs
The tabs along the top of the information area present information about the
following components:
LED and sensor information
Overall system information