2 – Operations and Administration
D000003-006 Rev. A 2-27
Q
2.2.6.1.1
Target Configuration Window Field Descriptions
The following are descriptions for each field in the Target Configuration window:
SNMP Target Addresses:
❥ Address Name
Specifies a unique, administrator-defined name the system uses to identify a row.
❥ Transport Domain
Specifies the transport type of the address contained in the
snmpTargetAddrTAddress object (e.g., 1.3.6.1.6.1.1 = udp,
1.3.6.1.4.1.1977.200.1 = tcp).
❥ Transport Address
Specifies the IP address in dotted decimal format.
NOTE: The combination of the Transport Domain and the Transport Address
determines the trap destination.
❥ Port
Specifies the TCP or UDP port that the SNMP trap is sent.
❥ Timeout
Specifies the time (in milliseconds) that the trap sender waits on a response
before re-sending the trap.
❥ Retry Count
Specifies the number of attempts to be made to send the trap after a timeout
condition occurs.
NOTE: Timeout and Retry Count are SNMP v2.c and above. Not applicable for
v1 traps.
❥ Tag List
Specifies which traps should be sent to this particular destination.
NOTE: RFC2233 specifies the link up/down traps. Including RFC2233 in the Tag
List specifies that the trap receiver will get link up/down traps.
❥ Parameters
Specifies a mapping to an entry in the SNMP Target Parameters table,
determining the version of SNMP to use.
❥ Storage Type