Filter
Top Products
3 – FVIC Configuration and Monitoring Features
Fibre Channel Configuration
3-20 D000003-006 Rev. A
Q
NOTE:The number in green box of the Name column represents how many
sessions are active for that SRP initiator. The number in the green box in the IOC
(X) Mapping column represents how many session are active for that map.
Figure 3-37. Click to Add Link
4. Click the Click to Add link of the SRP Initiator and column of the IOC. The IOC
is the path through the FVIC through which the IB traffic flows (i.e. it selects
one of the two HCA(s) on the FVIC). The Map Configuration Wizard is
displayed:
Figure 3-38. Map Configuration Wizard
NOTE:The FCP target device must be accessible through the IOC chosen in
order for the SRP initiator to communicate with the FCP target device.
5. Enter a map name applicable to the user environment.
6. For map type, choose Direct or Explicit. This example presents an Explicit
map type.
NOTE:If the SRP initiator only requires access to LUN 0 of the target device as
Host LUN 0, use a Direct map. In general, each disk of a JBOD must be configured
as a separate LUN. Depending on how a device is configured, the user may need
to configure multiple LUNs for communication with an “intelligent” target device. If
a storage device has multiple virtual drives, a Direct map to that device will allow
access to all virtual drives (LUNs). An Explicit map to such a device allows the
user to choose which LUNs to connect.