Filter
Top Products
Supplies and accessories_ 4
the paper transfer belt.
•Be careful not
to scratch the surface of the paper transfer belt.
5. Hold
ing the handle on the new paper transfer belt, align it with the slots
on the inside of the front door.
6. Lower the paper transfer belt until it is parallel with the front door and
firmly seated.
7. Close the front door to resume printing.
If the front door is not completely closed, the machine will not
operate.
Necessary precautions to take when installing
accessories
• Disconnect the power cord.
To avoid the possibility of an electrical shock, always disconnect the
powe
r cord when installing or removing ANY internal or external
accessories.
• Discharg
e static electricity.
The control board and internal accessories (netwo
rk interface card or
memory module) are sensitive to static electricity. Before installing or
removing any internal accessories, discharge static electricity from your
body by touching something metal, such as the metal back plate on any
device plugged into a grounded power source. If you walk around before
finishing the installation, repeat this procedure to discharge any static
electricity again.
• Activatin
g the added accessories in the PS driver properties.
After installing an accessory such as an optional tray, PS driver users
must do the add
itional setting. Go to the PS printer properties and set
the added accessory activated.
When installing accessories, the battery inside the machine is a
service component and needs to be replaced by an authorized
servicer. Do not change it by yourself.
There is a risk of an explosion if battery is replaced by an incorrect
type.
Activating the added accessories in printer
properties
After installing added accessories, you need to select it in the printer
properties of the printer driver in order to use it.
1. Install the driver (See "Installing USB connected machine’s driver" on
page 3 or "Installing network connected machin
e’s driver" on page 3).
2. Click the
Windows Start menu.
3. F
or Windows 2000, select Settings > Printers.
•Fo
r Windows XP/2003, select Printers and Faxes.
•Fo
r Windows 2008/Vista, select Control Panel > Hardware and
Sound > Printers.
•For Windows 7,
select Control Panel > Hardware and Sound >
Devices and Printers.
•Fo
r Windows Server 2008 R2, select Control Panel > Hardware >
Devices and Printers.
4. Right-click your machine.
5. F
or Windows XP/2003/2008/Vista, press Properties.
•Fo
r PS driver, select PS driver and right-click to open Properties.
For Windows 7 and Windows Server 2008 R2, from context menus,
select the Print
er properties.
If Printer properties item has ► mark, you can select other
printer drivers connected with selected printer.
6. In printer driver properties, select Device Options.
7. In prin
ter driver properties, set the necessary options.
8. Click OK.
Upgrading a memory module
Your machine supports DIMM (Dual Inline Memory Module). Use this
memory module slot to install additional memory.
When you are expanding the memory capacity, you can add a memory
module to the
vacant memory slot (See "Available accessories" on page 2).
We recommend the use of only genuine Samsung DIMM's. You may void
your warranty if it is determined that your machine problem is being caused
by third party DIMM's.