Filter
Top Products
216 SANRAD V-Switch User Manual
storage discovery
This command resets the Fiber Channel loop and reregisters all attached
storage devices. This command is used after adding or removing storage
devices from the V Switch topography. Because this command resets the
FC loop, it will cause a failure of any I/O operations being executed when
the command is invoked.
storage discovery
storage blink activate
This command allows you to blink a storage device to identify it.
storage blink activate
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-s
STORAGE DEVICE ALAIS OF DEVICE
TO BLINK
MANDATORY
Stor_1
-t
TIME LENGTH OF TIME TO
BLINK DEVICE
MANDATORY
1-3600
SEC
0=
FOREVER
120
storage blink abort
This command stops a storage device from blinking.
storage blink abort
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-s
STORAGE DEVICE ALAIS OF DEVICE
TO BLINK
MANDATORY
Stor_1
storage show
This command shows all storage devices connected to the V Switch.
storage show
Table 43: Storage Devices
Alias Entity Name LUN Oper. Status Type
Stor_1 0102030405060708 0 Disabled disk
Stor_2 090a0b0c0d0e0f10 0 Enabled entire
Stor_3 090a0b0c0d0e0f10 1 Enabled split