Filter
Top Products
226 SANRAD V-Switch User Manual
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-vol
VOLUME ALIAS OF VOLUME
TO CHANGE
MANDATORY
Subdisk7
-na
NEW ALIAS NEW ALIAS FOR
VOLUME
MANDATORY IF
CHANGING ALIAS
Simple7
-lt
LOAD THRESHOLD PERCENTAGE FULL
AT DESTINATION
TO TRIGGER AN
ALARM
MANDATORY IF
CHANGING LOAD
THRESHOLD
70
volume remove
This command removes a volume from the system. The volume must be at
the top of the hierarchy. The volume cannot be exposed; the volume LU
must be inactivated.
volume remove
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-vol
VOLUME ALIAS OF VOLUME
TO REMOVE
MANDATORY
Stripe3
volume remove -all
This command removes a volume and all volumes composing it in the
hierarchy. The volume must be at the top of the hierarchy. The volume
cannot be exposed; the volume LU must be inactivated. Simple volumes
will convert back to their component disks or subdisks.
volume remove -all
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-vol
VOLUME ALIAS ALIAS OF TOP-
LEVEL VOLUME TO
REMOVE
MANDATORY
Stripe 1
volume replace
This command replaces a volume with another volume. Use this command
after a disk failure to replace a volume used in a storage hierarchy with a
volume on a functional disk.
If you are replacing a volume used as part of a mirrored volume, use the
CLI command volume mirror-synch to synchronize the replacement
volume with the other mirrored volume(s). See the working example:
“Replacing a Mirrored Volume,” page 256.