Filter
Top Products
Chapter 5: V-Switch Cluster Configuration 75
Configuring a V-Switch Cluster
Setting the V-Switch ID
When you configure a cluster, you must give each V-Switch a different
device ID for proper cluster functioning. Use the CLI command device
set to configure the V-Switch ID for each V-Switch.
device set
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-id
V-SWITCH ID ID OF V-SWITCH
IN A CLUSTER
EACH V-SWITCH
MUST HAVE A
DIFFERENT
ID
MANDATORY IN
A CLUSTER
0
OR 1
1
Example:
There are two V-Switches in a cluster. In V-Switch 1 the ID is set to 1.
device set –id 1
In V-Switch 2 the ID is set to 0.
device set –id 0
Adding a Neighbor
All CLI names and
aliases are case
sensitive.
When you configure a cluster, you must tell each V-Switch that it has a
neighbor and how to contact its neighbor. Use the CLI command
neighbor add to inform each V-Switch of its neighbor.
You must inform each V-Switch of its neighbor in a cluster. That means
that you must tell V-Switch 1 of V-Switch 2 and V-Switch 2 of V-Switch 1.
When creating a cluster, first ensure that you have configured all IP
addresses in the correct active/inactive phase as well as portals and IP
routes on both V-Switches. For more information on configuring the V-
Switch, see “V-Switch Configuration,” page 47.