Filter
Top Products
86 SANRAD V-Switch User Manual
storage blink activate –s Stor_1 –t 120
Use the CLI command storage blink abort to stop the blinking before
the end of the set time.
storage blink abort
You need to define one parameter to stop blinking a storage device:
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-s
STORAGE DEVICE ALAIS OF DEVICE
TO BLINK
MANDATORY
Stor_1
Once a storage device has been identified, use the CLI command storage
set to change the device alias or include helpful information on the device.
storage set
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-s
STORAGE ALIAS STORAGE ALIAS TO
MODIFY
MANDATORY
Stor_1
-na
NEW ALIAS NEW ALIAS FOR
STORAGE
OPTIONAL
Disk2JBOD5
-info
INFORMATION INFORMATION ON
STORAGE TO SET
OPTIONAL
save_for_snap
shots
Example:
The alias of Stor_1 is changed to Disk2JBOD5 for easier identification and it
is noted to save the disk for snapshots.
storage set –s Stor_1 –na Disk2JBOD5 –info save_for_snap
shots
The V-Switch supports write cache enabling for increased performance.
Use the CLI command storage disk set to enable or disable the write
cache.
storage disk set
You need to define two parameters to change a device’s write cache setting:
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-d
DISK DISK DEVICE MANDATORY
Disk2JBOD5
-wce
WRITE CACHE
ENABLED
WRITE CACHE
FUNCTION
MANDATORY
YES OR NO
yes