Filter
Top Products
48 SANRAD V-Switch User Manual
Configuring the V-Switch 3000 Management
Parameters via LCD
After successfully powering up, the V-Switch 3000 LCD display panel
displays:
V-Switch 3000
Status: OK
Using the Enter and arrow buttons, you toggle between LCD screens and
input the V-Switch management parameters. The Back and Forward
buttons toggle between spaces. The Up and Down buttons scroll between
values in a space. Press Esc at any time to escape from a field or return to
the previous screen level.
10244
Figure 26. LCD Display Panel and Buttons
STEP 1. T
OGGLE TO THE IP CONFIGURE SCREEN
The default
management port via
LCD is Eth1.
From the main status screen, press Enter. The IP Configuration screen
appears.
IP CONFIG
Press Enter again. The IP Config Eth1 Port screen appears.
IP Config
ETH1 Port
Press Enter again. The Insert IP screen appears.
Use the Back and Forward buttons to toggle to the desired interface: mgn or
eth1.
STEP 2. ENTER MANAGEMENT PORT IP ADDRESS
Enter the management port IP address using the arrow buttons. The Back and
Forward buttons toggle between spaces. The Up and Down buttons scroll
between values in a space.
Insert IP
_ _ _._ _ _._ _ _._ _ _
2 1 2.1 9 9.0 4 3.0 4 6
Press Enter to enter the IP address and progress to the IP Mask screen.
STEP 3. ENTER MANAGEMENT PORT IP MASK