Filter
Top Products
105
Fault parameters
ILF1 Parameter name: Option card 1 fault code
Logic address: 7134 = 16#1BDE Type: UINT
CANopen index: 2029/23 Read/write: R
INTERBUS index: 5FB0/9A Unit: 1
DeviceNet path: 84/01/87 Factory setting:
The fault remains saved in the parameter, even if it disappears.
The parameter is reset after the drive is disconnected and then reconnected.
0 = No fault
1 = Loss of internal communication with the drive
2 = Hardware fault detected
3 = Error in the EEPROM non-volatile memory checksum
4 = Faulty EEPROM non-volatile memory
5 = Faulty Flash memory
6 = Faulty RAM memory
7 = Faulty NVRAM memory
8 = Faulty analog input
9 = Faulty analog output
10 = Faulty logic input
11 = Faulty logic output
101 = Unknown card
102 = Exchange problem on the drive internal bus
103 = Time-out on the drive internal bus (500 ms)
ILF2 Parameter name: Option card 2 fault code
Logic address: 7135 = 16#1BDF Type: UINT
CANopen index: 2029/24 Read/write: R
INTERBUS index: 5FB0/9B Unit: 1
DeviceNet path: 84/01/88
The fault remains saved in the parameter, even if it disappears.
The parameter is reset after the drive is disconnected and then reconnected.
Same values as ILF1.
Fdrd Parameter name: Ethernet fault code
Terminal display: [FDR fault]
Logic address: 64233 = 16#FAE9 Type: UINT
CANopen index: - Read/write: R
INTERBUS index: - Unit: -
DeviceNet path: -
When an Ethernet fault is present, this parameter is used to ascertain the cause of the fault.
The fault code remains saved after the disappearance of the fault.
2: The FDR configuration file is not compatible with the type of drive (e.g., incorrect drive rating)
3: Error reading the FDR configuration file on the server
4: Error writing the FDR configuration file to the server
5: Error writing the FDR configuration file to the drive (e.g., the drive is in forced local mode)
7: Time-out for receipt of the FDR configuration file from the server
9: Duplication of IP address
12: The FDR configuration file is missing
Code Description