Sun Microsystems V20z Server User Manual


 
4-1
CHAPTER
4
Maintaining the Sun Fire V40z
Server
This chapter describes how to add, replace and configure components in the Sun Fire
V40z server after it has been set up.
Caution –
Before touching or replacing any component inside the server, disconnect
all external cables. If possible, place the server on a grounded electrostatic-discharge
(ESD) pad and ALWAYS wear a properly grounded, antistatic wrist strap.
For instructions on maintaining a Sun Fire V20z server, see Chapter 3.
This chapter contains the following sections:
“Tools and Supplies Needed” on page 4-1
“Powering Off the Server and Removing the Cover” on page 4-2
“Locations of Sun Fire V40z Components” on page 4-3
“Customer-Replaceable-Unit Replacement Procedures” on page 4-12
“Sun Fire V40z Indicators, Switches and Jumpers” on page 4-78
To determine and isolate a faulty component, refer to the
Sun Fire V20z and Sun Fire
V40z Servers—Troubleshooting Techniques and Diagnostics Guide
(817-7184).
4.1 Tools and Supplies Needed
#2 crosshead screwdriver
Antistatic wrist strap
Alcohol pads (for CPU replacement only)