Filter
Top Products
Chapter 3 Maintaining the Sun Fire V20z Server 3-33
3.5.11.2 Removing a memory module
1. Power off the server, including any attached peripherals, and disconnect the
server from the electrical outlet.
Refer to “Powering Off the Server and Removing the Cover” on page 3-2.
2. Locate the memory-module connector in which you will install or replace a
memory module.
3. Remove a memory module by pressing down on the ejector bars at both ends of
the memory module’s socket (see
FIGURE 3-26).
FIGURE 3-26 Removing a Memory Module
3.5.11.3 Installing a Memory Module
1. Ensure that the memory-module socket’s ejectors are open (rotated outward) to
allow the new module to be inserted.
2. Align the memory module’s edge connector with the alignment key and insert the
memory module into the connector.
Note – The manufacturer and capacity of both modules in a given memory bank
must be identical.
3. Before re-installing the cover on the server, check the routing of all cables for
obstructions.