Sun Microsystems V20z Server User Manual


 
Chapter 3 Maintaining the Sun Fire V20z Server 3-15
To Remove an Existing PCI Card
1. Unfasten all cables connected to the card.
2. Withdraw the card and riser from the PCI card connector on the motherboard.
3. Remove the PCI card from the riser.
Note – If the PCI card is being removed, but not replaced with another card:
Re-install the empty riser assembly in the empty PCI-card connector on the
motherboard. Re-install the PCI-card slot cover.
To Install a New PCI Card
1. Loosen the screw holding the card latch.
2. Raise the latch as far as possible and then pivot it towards the rear of the chassis.
3. Withdraw the PCI card slot cover (see
FIGURE 3-6).
FIGURE 3-6 PCI Card Slot Cover
4. Remove the card riser assembly from the PCI card connector on the motherboard.
5. Install the PCI card in the riser assembly (see
FIGURE 3-7).
6. Re-install the riser and card in the connector on the motherboard.