Filter
Top Products
Installation 2 - 3
Installing the VC5090 in a Forklift
Follow the instructions below to properly install the VC5090 in a forklift.
•
Determine the best location for mounting the vehicle computer taking into consideration the driver’s field
of view and ease of accessing the vehicle computer.
•
Install the appropriate mounting hardware.The VC5090 ships with four cap screws (3/8” - 16 - 2”) for
securing the mounting bracket. If the supplied cap screws are not long enough, use 3/8” - 16 - X cap
screws where X represents the length in inches of the required cap screws.
•
Connect the vehicle computer to the vehicle’s wiring system.
Positioning the Vehicle Computer
•
Determine the best position for the vehicle computer and all the associated components. If a similar
vehicle computer was previously installed, check to see if the position it used is suitable for the VC5090.
•
Test the installation for at least 30 minutes before installing on another vehicle. Record all details:
• Check that the position of the vehicle computer does not obstruct vehicle controls.
Figure 2-2
View Obstruction
• Check that the vehicle computer does not obstruct the driver's view.
• Check the position of the vehicle computer for user comfort over long periods.
• Check positioning to avoid extreme wrist angles that may cause injury.
CAUTION A competent engineer must perform the installation in a vehicle. Improper installation can injure the
operator and damage your vehicle and/or the VC5090.