Filter
Top Products
2 - 8 VC5090 Vehicle Computer Product Reference Guide
Mounting on a Dashboard or Horizontal Surface Example
The diagram below illustrates a typical installation where the vehicle computer is mounted on a dashboard or
horizontal flat surface.
Figure 2-8
Mounting on a Vehicle Shelf
Routing Electrical Cables
•
Establish a neat route for the cable, staying clear of moving parts or hot surfaces.
•
Fix the cable to existing cable runs inside the vehicle using cable ties, but make sure they are away from
any moving or hot surfaces.
•
When the cabling must go through a panel, use a suitable gland.
•
When fixing the conduit or cable on the outside of a vehicle, use P-Clips. Either drill and tap the hole or
use a nut and bolt to secure the clip.
•
Ensure the cable does not have tight bends. The minimum recommended radius is 63.5 mm (2.5 in.).
•
On electric vehicles, take the power from as close to the battery as possible, but not directly from the
battery terminals, and not before any main fuse.
•
On gasoline, diesel or propane vehicles, take the power from as close to the battery terminals as
possible, and avoid using existing wiring.
•
All fuses must be as close as possible to the power source.
•
If you are unsure of the correct power source, contact the vehicle manufacturer for more information.
NOTE If mounting to a thin surface, a reinforcing plate maybe required.
Nuts
Lock Washers
Cap Screws
Mounting Bracket
Mounting Surface
Flat Washers
Lock Washers
Flat Washers