Filter
Top Products
097-58001-02 Revision G – April 2008 TimeProvider User’s Guide 113
Chapter 4 Provisioning the TimeProvider
Provisioning the Input Reference
ED-SYNC:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;
This command has a default access level of ADMIN.
Sample Commands
ED-SYNC::PRS:::QLEVEL=1;
ED-SYNC::INP1:::QLEVEL=1;
ED-SYNC::INP2:::QLEVEL=1;
This series of commands sets the QLEVEL for all inputs to the same level; if you
also provision the PRIORITY level to the same value, then you have set up a
non-revertive switching strategy.
Autonomous Message
TP-SSU 03-10-24 10:54:44
A 1183 REPT EVT
“PRS,EQPT:NA,QLEVEL,NSA,003-10-24 10-54-44:\"USER
ASSIGNED QUALITY LEVEL HAS CHANGED,1\””
;
Setting the Input Priority Level
The PRIORITY level works together with the QLEVEL parameter (described in
Setting the Input Quality Level, on page 112) to determine the switching strategy.
The PRIORITY level is the second factor the TimeProvider uses to determine which
input to use when the original primary input becomes unavailable.
Use the ED-SYNC command to set the PRIORITY level of the selected reference.
ED-SYNC:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;
This command has a default access level of ADMIN.
<aid> <keyword> <value> Description Default value
PRS
INPp (p = 1 | 2)
GPS
QLEVEL 1 = PRC
2 = UNK/STU
3 = TYPE II/ST2
4 = TYPE I
5 = TYPE V/TNC
6 = TYPE III/ST3E
7 = TYPE IV/ST3
8 = G.813OPT3/SMC
9 = DUS
Sets the Quality
Level for the
specified input
2
<aid> <keyword> <value> Description Default value
PRS
INPp (p = 1 | 2)
GPS
PRIORITY 2 | 3 | 4 Sets the priority for
the selected input
GPS = 1
PRS = 2
INP1 = 3
INP4 = 4