Filter
Top Products
097-58001-02 Revision G – April 2008 TimeProvider User’s Guide 137
Chapter 4 Provisioning the TimeProvider
Provisioning SNMP Parameters
Autonomous Message
TP-SSU 03-05-15 09-59-09
A 1166 REPT EVT EQPT
“IMC,EQPT:FEATURE,TC,03-05-15 09-59-09,,,,:\”System
Feature has been enabled\””
;
Adding a User
You use the Enter User Security command to add an SNMP user to the
TimeProvider:
Changing A User’s Security Parameters
You use the Edit User Security command to change the security parameters, such
as authentication protocol, authentication password, and privacy password.
Displaying the Connected Users
You use the Retrieve User Security command to view the users connected to the
TimeProvider.
Deleting a User
You use the Delete User Security command to delete TL1 and SNMP users from
the TimeProvider.
Setting Up SNMP Traps, Informs, and Notifications
You can set up to five users to send out a trap, and up to five managers to receive
the trap. You must also set up the timeout and retrry parameters for each
user/manager.
SNMP v1
To set up Traps, create an SNMP v1 community using the ENT-USER-SECU
command. Add a MGRx and SENDERx using the ED-EQPT command. There is no
Inform capability in SNMP v1. The engineid parameter in the ENT-USER-SECU
command is ignored; the IFTOUTx and IFRETRYx parameters are not used.
SNMP v2C
To set up Notifications, create an SNMP v2C community using the
ENT-USER-SECU command. Add a MGRx and SENDERx using the ED-EQPT
command. Set the IFTOUTx and IFRETRYx parameters to 0.
To set up Informs, create an SNMP v2C community using the ENT-USER-SECU
command. Add a MGRx and SENDERx using the ED-EQPT command. Set the
IFTOUTx and IFRETRYx parameters to a nonzero value.