Filter
Top Products
097-58001-02 Revision G – April 2008 TimeProvider User’s Guide 205
Appendix A Factory Default Values
Alarm Default Values
Alarm Default Values
This section describes the default values for alarms in the TimeProvider. Table A-2
includes the default error delay, which is set using the FLTDELAY keyword in the
ED-SYNC command (see Provisioning System-Level Alarms, on page 130).
SET-SID Admin Yes
RTRV-ALM User Yes
RTRV-COND User Yes
RTRV-CRAFT User Yes
RTRV-HDR None Yes
RTRV-INV User Yes
ACT-USER None No
RTRV-USER User Yes
CANC-USER User No
PING User Yes
GEN-EVT User Yes
Table A-2. Default Alarm Settings
Alarm ID
Default
Error Delay
Error Delay
Editable?
Default Alarm Level
SSU Mode PRR Mode SUB Mode
System-wide Alarms
COMPATIMMEDNoMJMJMJ
EXTALM1 IMMED No MJ MJ MJ
EXTALM2 IMMED No CR CR CR
EXPFAIL IMMED No MJ MJ MJ
PWRAIMMEDNoMJMJMJ
PWRBIMMEDNoMJMJMJ
IOC1EQPTIMMEDNoMJMJMJ
IOC2EQPTIMMEDNoMJMJMJ
Table A-1. Default Access Levels for TL1 Commands (Continued)
Command Default Access Level Editable?