Filter
Top Products
27
ICC
be used to actually control the drive via the option board: all other drive command
parameters can only be monitored via the option board.
Monitor Parameters: Drive monitor parameters are available.
10.4.3 Parameter Subgroup Selection List
Subgroups can be used to further filter the
parameters of a group that are to be
displayed in the Parameter List. Refer to
Figure 12.
If the group currently selected in the
Parameter Group Selection List (refer to
section 10.4.2) has subgroups available,
then choosing one or more desired
subgroups will further filter the parameters
that are displayed in the Parameter List. If the currently-selected group does not
have any available subgroups, then only the “All” subgroup will be shown, and all
parameters in that group will be shown in the Parameter List.
10.4.4 Parameter List
The bottom half of the Monitor tab contains the parameter list (refer to Figure 13).
The parameters that are displayed in the list at any given time depend on the
groups/subgroups selected, as well as whether or not any filters have been applied
(refer to section 10.4.5).
Figure 13: Parameter List
The first two columns of the Parameter List show the parameter name and the
register number that provides access to that parameter, and were discussed in detail
in section 9. The third column contains the parameter descriptions, which are used
by the filter function. The last column performs two functions: it displays the current
Figure 12: Parameter Subgroup
Selection List