Filter
Top Products
36
ICC
10.7.2 Drive Configuration Parameter Write Selection
Figure 27 shows the check box selection that
determines whether drive configuration
parameters (registers 1..1000) will be written only
to the drive’s RAM, or to both the drive’s RAM
and EEPROM when they are changed via the
interface card.
If written to RAM only, then parameter value changes will be lost when the drive is
power cycled or otherwise reset. If written to both RAM and EEPROM, then
parameter value changes will be retained. When enabling writes to EEPROM, be
sure to always observe Toshiba’s restrictions on the number of times a configuration
parameter may be written to EEPROM before possible EEPROM damage occurs.
This selection affects all configuration parameters, and applies regardless of the
interface card mechanism used to modify the parameters (control protocol data write,
modification via the web page “monitor” tab, timeout configuration setting etc.)
Note that ASD Interface CPU firmware version V1.100 or later is required for this
feature to be supported (refer to Figure 10 on page 26 for how to determine the ASD
interface CPU version.)
10.7.3 Authentication Configuration
Figure 28 shows the entry boxes used to modify
the authentication credentials. The case-sensitive
username and password can contain letters
(“a”..”z” and “A”..”Z”) and numbers (“0”..”9”), and
can each be up to 80 characters in length.
Be sure to make a note of the new settings
whenever these credentials are changed, as they
must be entered whenever the web page is
accessed, an FTP session is initiated, or when a configuration change is performed
via the Finder utility. Contact ICC for assistance if you have forgotten your
customized credentials.
Figure 27: RAM Only or
RAM/EEPROM Write Selection
Figure 28: Authentication
Configuration