Filter
Top Products
32
Install the new Drum Unit into
the machine, aligning the guides
of the Unit with the grooves in-
side the machine.
Color coordinated “1” labels
have been affixed to the Drum
Unit and to the inside of the ma-
chine. Install the Drum Unit by
aligning these labels.
Make sure the Drum Unit is in-
serted inside the machine as far
as it will go.
IMPORTANT:
• Never touch the photocon-
ductive drum (the green sur-
face) of the Drum Unit. If the
surface is scarred or
scratched, it will cause print
quality problems.
• Do not expose the photocon-
ductive drum of the Drum
Unit to light for more than 3
minutes. If the Drum Unit is
to be left anywhere outside
the facsimile, be certain to
cover it with cloth, paper,
etc.
Install the New Drum
Unit
3
45
Holding onto the Toner
Cartridge’s handle, lower it into
the machine. Make sure that the
four pins (two on each side) fit
into the grooves inside the ma-
chine.
Color coordinated “2” labels
have been affixed to the Toner
Cartridge and to the inside of
the machine. Install the Toner
Cartridge by aligning these la-
bels.
As the Toner Cartridge is low-
ered into the machine, its
handle will rotate first to the rear
of the machine and then to the
front.
The cartridge will click into place
when it is completely installed.
40
Press down on the Top Cover
until a “Click” is heard to ensure
the latches engage.
Close the Top Cover
5
43
2
2
2
2
Install the Toner Cartridge
4
41
42
Perform the following procedure
to reset the Drum Unit counter
after you replace the Drum Unit.
Press:
+
+
+
+
1.YES
RESET DRUM COUNT
2.NO
Reset the Drum
Counter
6
Drum Unit Replacement - continued