Filter
Top Products
2.18 Fingerprint sensor 2 Troubleshooting Procedures
3. After starting Windows, make sure that the name of Account (e.g. “TOSHIBA”), which
has been inputted in item 3 in Procedure 1 at the top of [Start].
Procedure 4 Connector Check and Replacement Check
The connector CN9540 on the FS board is connected to the connector CN9530 on the system
board.
Check 1 Check the FS cable is firmly connected to the connector CN9540 on the FS board
and connector CN9530 on the system board. If not, connect it firmly. If the finger
sensor is still not functioning properly, perform Check 2.
Check 2 The FS cable may be faulty. Replace it with a new one. If the problem persists,
perform Check 3.
Check 3 The FS board may be faulty. Replace it with a new one. If the problem persists,
perform Check 4.
QOSMIO F30 Maintenance Manual (960-555) [CONFIDENTIAL] 2-69