Filter
Top Products
4 Replacement Procedures 4.10 Cover assembly
4-32 [CONFIDENTIAL] QOSMIO F30 Maintenance Manual (960-555)
Installing the cover assembly
The following describes the procedure for installing the cover assembly (See Figure 4-14 to
4-18).
1. Install the cover assembly to the base while engaging latches.
2. Connect the LED cable to the connector CN9500 on the system board.
3. Arrange the Bluetooth antenna cable in place and stick the insulator.
4. Connect the switch cable to the connector CN9650 on the system board.
5. Connect the fingerprint sensor cable to the connector CN9530 on the system board.
6. Connect the volume cable to the connector CN3330 on the system board.
7. Connect the touch pad cable to the connector CN3201 on the system board.
8. Connect the LCD cable to the connector CN5500 on the system board.
9. Install the LCD connector cover in place.
10. Turn over the computer.
11. Install the ODD slot bezel and secure it with the following screws.
• M2.5×4B FLAT BIND screw ×2
12. Connect the GPU fan cable to the connector CN8781 on the system board.
13. Connect the AV-IN cable to the connector PJ650 on the analog TV tuner.
14. Secure the cover assembly with the following screws
• M2.5×4B FLAT BIND screw ×3 (Described as"4"in the figure 4-15)
• M2.5×8B FLAT BIND screw ×4 (Described as"8"in the figure 4-15)
• M2.5×16B FLAT BIND screw ×10 (Described as"16"in the figure 4-15)