Filter
Top Products
3 Tests and Diagnostics 3.30 IEEE 1394 Test Program
3-80 [CONFIDENTIAL] QOSMIO F30 Maintenance Manual (960-555)
3.30 IEEE 1394 Test Program
To execute the IEEE 1394Test, use the IEEE 1394 Test program disk. Finish the tests of the
Diagnostics disk (No.1) by selecting 99 - EXIT TO DIAGNOSTICS MENU in the
DIAGNOSTIC TEST MENU. Then in the DIAGNOSTICS MENU, select 9 - EXIT TO
MS-DOS.
Insert the IEEE 1394 Test program disk in the floppy disk drive and turn on the power. The
following message will appear:
********************************************************************
* --------------------------------------------------------- *
* EEE1394 test menu (For repair) *
* --------------------------------------------------------- *
* *
* ============= Select test NO. and [Enter] ============= *
* *
* 1 ....Transmit & Receive test *
* 2 ....Responder set *
* 3 ....1394 GUID Display *
* *
********************************************************************
.... Press test number [1-3] ?
Press the number you want to test and press Enter.
Subtest 01 Transmit & Receive test
This subtest tests the transmission/ reception function of the IEEE1394 port.
Specifies the data size and transfer speed between the responder connected
with an IEEE1394 cable, and sends, receives and compare data.
To execute this subtest, press 1 key and Enter.
Subtest 02 Responder set
Before executing Subtest 01, connect the target PC and responder PC with a
IEEE1394 cable and execute this subtest to initialize the responder PC.
To execute this subtest, press 2 key and Enter.
Subtest 03 1394 GUID Display
GUID can be displayed.
To execute this subtest, press 3 key and Enter.