Filter
Top Products
4.21 System board/DC-IN jack 4 Replacement Procedures
4. Remove the DC-IN jack from the connector CN8800 on the system board.
CN8800
(Back of the system board)
DC-IN jack
Figure 4-34 Removing the DC-IN jack
Installing the system board/DC-IN jack
The following describes the procedure for installing the system board/DC-IN jack (See
Figure 4-33 and 4-34).
1. Connect the DC-IN jack to the connector CN8800 on the system board.
2. Install the system board to the base assembly and stick the insulator in place.
3. Connect the speaker cable to the connector CN6170 the system board.
4. Install the DC-IN jack to the slot.
QOSMIO F30 Maintenance Manual (960-555) [CONFIDENTIAL] 4-53