Filter
Top Products
4 Replacement Procedures 4.31 LCD unit/FL inverter
4-76 [CONFIDENTIAL] QOSMIO F30 Maintenance Manual (960-555)
Installing the LCD unit/FL Inverter
The following describes the procedure for installing the LCD unit and FL inverter (See
Figure 4-49 to 4-54).
1. Install the LCD support to the LCD unit and secure them with the following screws.
• M2.0×3S S-THIN HEAD screw ×4
2. Stand the LCD unit on the display cover and connect the LCD cable to the connector
on the back of the LCD and stick the glass tape on it.
3. Secure the LCD unit with the following screws.
• M2.0×6S BIND screw ×4
4. Connect the LCD cables to the connectors on the FL inverter.
5. Connect the HV cables to the connectors on the FL inverter.
CAUTION: In a two-lamp LCD, be careful to connect the LCD/HV cables to the correct
connectors of the FL inverter.
6. Install the FL inverter and secure it with the following screw.
• M2.0×6S BIND screw ×1
7. Stick one insulator on the FL inverter and insert one insulator under the LCD unit.
8. Install the LCD mask while latching.
NOTE: When installing the display mask, make sure there is no gap between the LCD
mask and the display rear cover.
9. Secure the LCD mask with the following screws.
• M2.5×6B FLAT BIND screw ×6
10. Stick the mask seals and mask pads.
11. Install the hinge cap while fitting the latches.
CAUTION: When installing the hinge cap, do not mistake the left for the right and vice
versa. “L” for the left and “R” for the right are marked on the hinge cap.