Filter
Top Products
6. PROGRAMMING OPERATIONS EO1-11152
6.16 Display Message Programming (Submode 31)
6-43
6.16 Display Message Programming (Submode 31)
The “DISPLAY MESSAGE” here means the message to be displayed in the 16-digit dot windows of the Operator
Display panel while the Mode Lock of the terminal is in the “LOCK” position. This display message may be used
as information, commercial message, welcoming greeting, etc.
Any time outside a sale
Mode Lock: SET
31 [X] | Message Line No.
| [ST] Character Entries [ST] [AT/TL]
NOTES: 1. When the option “Store Message SCROLLING DISPLAY” is selected, four lines (Line Nos. 1 to 4)
are available. Even when the option “Store Message 16 CHARACTERS HELD” is selected, four
lines (Line Nos. 1 to 4) are available. In this case, refer to the “Store Message Display” operation
to display the respective message lines.
2. When the “SCROLLING DISPLAY” option is selected, a maximum of 64 characters can be
entered consecutively after designating Line No.1 at first and depressing [ST] for each line end.
3. The character must be regular-sized only.
4. The DISPLAY MESSAGE set here will also appear in the “REG” or “MGR” mode if so designated
by system option.
Example) To program the following display message under the “SCROLLING DISPLAY” option:
T
H
I
S
C
O
U
N
T
E
R
I
S
Line No. 1
C
L
O
S
E
D
.
P
L
E
A
S
E
Line No. 2
G
O
T
O
A
N
O
T
H
E
R
,
T
Line No. 3
H
A
N
K
Y
O
U
.
.
.
Line No. 4
* Allowed for sequential Line No. only
Repeat for other lines.
(1 to 4; max. 4 lines)
(Max. 16 characters per line.
Regular-size only.)
OPERATION
CONDITION