Filter
Top Products
5. PROGRAMMING OPERATIONS EO1-11152
5.1 Programming Operations Common with Standalone ECR Level
5- 1
5. PROGRAMMING OPERATIONS
The system should be programmed fully by your local TOSHIBA TEC representative at the time of delivery
according to the user’s requirements so that daily operations can immediately start. However, some data must be
added or changed daily or in a longer period. Since the volume of programming contents for the system is too
large, this chapter and the following two chapters are provided as guide lines of the user’s daily programming and
maintenance operations. If there are any unclear points or program data other than listed here must be changed
or added, please contact your TOSHIBA TEC representative. Please also note that some programming
operations introduced in the Standalone Level are modified or not available on in-line terminals.
5.1 Programming Operations Common with Standalone ECR Level
The following is the table of programming operations which are introduced in the Manager’s Guide for the
Standalone Level and can be operated on in-line terminals as well, with the Submode No. and operation
sequence unchanged. However, on in-line terminals, these are usually operated on the Master Terminal only
and down-line-loaded (DLLed) to all the Satellite Terminals. Therefore, if any program data is changed, a DLL is
further necessary to load the new data (after the change) to all the Satellite Terminals (to be described in Chapter
6).
PROGRAMMING JOB LIST
Master
*1
: Programming job to be available when the [RTR] key is activated on the Master Terminal
Satellite
*2
: Programming job to be available on the Backup Master Terminal and the Satellite Terminal when the
[RTR] key is off on the Master Terminal
O: Available
Terminals
Submode
No.
Programming Job
Master
*1
Satellite
*2
1
Store Name Message, Commercial Message, and Footer Logo Message
Programming
O O
2 Cashier Code and Name Programming O
3 Department Table Programming O
4 PLU Table Programming O
5 Time Setting or Adjustment O O
6 Date Setting or Adjustment O O
8 Amount Limit Setting for Function Keys O O
15 Customer File Code (Check Track No.) and Name Programming O
20 Salesperson Code and Name Programming O
25 Link PLU Table Programming O
26 Tare Table and General Unit Weight Setting O
27 PLU Preset-code Key Setting O O
31 Display Message Programming O O
35 Negative Amount Key Limit Amount Setting O
40 PLU Price Dollar Discount/Extra Charge Amount Setting O
Department Preset Price Setting or Changing O
PLU Preset Price Setting or Changing,
Whole Package Quantity Changing
O
%+ and %- Preset Rate Setting O O
Preset Rate Setting for Selective Itemizers O O
Foreign Currency Exchange Rate Setting O
Tax Table Programming O
No
Submode
Store/Register No. Setting O O