Filter
Top Products
6. OUTLINE OF PREPARATION PROCEDURE BEFORE OPERATING THE ECR EO1-11155
6.1 Installing/Replacing the Receipt/Journal Roll
6- 4
5. Fully close the receipt cover until it clicks.
6. Press and hold the [RF] key for a few seconds and
make sure that the receipt paper is fed correctly. If
it is not fed correctly, start from Step 1 again.
7. Press the [C] key to cancel the error status.
Then the status shown in the figure is displayed.
8. Manually cut the receipt paper which was fed.
Receipt Cover
RF
X
Current time is displayed here.
C