Filter
Top Products
TECRA M2 6-17
Power and Power-Up Modes
■ Disable (button)
Click this button to invalidate the token. You cannot revalidate old
tokens, but you can use the same SD cards to create new tokens.
Supervisor password
If you set a supervisor password, some functions might be restricted when
a user logs on with the user password. To set a supervisor password,
execute the file TOSUP.EXE. The file is located at:
C:\Program Files\Toshiba\Windows
Utilities\SVPWTool\TOSUP.EXE
This utility lets you do the following:
■ Register, delete or change the supervisor password.
■ Create or invalidate a supervisor password token
■ Specify restrictions for general users.
Starting the computer by password
If you registered a password, there are two ways to start the computer:
■ Insert a token before you turn on the computer. The computer will start
normally, without displaying a password prompt.
■ Enter the password manually.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3, Getting Started.
The following message will appear in the LCD:
Password=
2. Enter the Password.
3. Press Enter.
When you format an SD Memory card, all data will be deleted. Be sure to
save data on the card to other media before you format the card.
This function in the TOSHIBA Password Utility lets you invalidate only
supervisor tokens or all tokens, including user and supervisor tokens.
The password is necessary only if the computer was shut down in boot
mode. It is not needed in Hibernation or Standby mode.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry password
entry.