Filter
Top Products
TECRA M2 8-7
Optional Devices
Installing memory module (Main memory)
To install a memory module, make sure the computer is in boot mode then:
1. Turn the computer off in boot mode. Refer to the Turning off the power
section in Chapter 3, Getting Started.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-Up Modes.)
4. Remove the screw that becomes visible when the battery pack is
removed and turn the computer right side up.
Removing the screw
5. Slide the display latch on the front of the computer to the right and open
the display panel.
6. Insert a thin object under the rim of the keyboard brace and lift out the
brace.
7. Remove two screws securing the keyboard.
Be sure to install memory module to Slot A. The computer does not boot
when Slot A is vacant.
Use a 0-bit, Phillips screwdriver to remove and fasten screws. Use of an
incorrect screwdriver can damage the screw heads.
Remove a keyboard brace after surely performing step 4. If step 4 is not
performed, there is a possibility of damaging a keyboard brace.