Filter
Top Products
TECRA M2 7-6
HW Setup
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]Sets PXE as the protocol. (Default)
[RPL]Sets RPL as the protocol.
Built-in HDD −>
2nd HDD −> PC
Card(Default)
The computer will look for the Built-in HDD first,
next the 2nd HDD and then the PC Card (Default).
2nd HDD −> Built-
in HDD −> PC Card
The computer will look for the 2nd HDD first, next
the Built-in HDD and then the PC Card.
Built-in HDD −> PC
Card −> 2nd HDD
The computer will look for the Built-in HDD first,
next PC Card and then the 2nd HDD.
2nd HDD −> PC Card
−> Built-in HDD
The computer will look for the 2nd HDD first, next
the PC Card and then the Built-in HDD.
PC Card −> Built-
in HDD −> 2nd HDD
The computer will look for the PC Card first, next
the Built-in HDD and then the 2nd HDD.
PC Card −> 2nd HDD
−> Built-in HDD
The computer will look for the PC Card first, next
the 2nd HDD and then the Built-in HDD.
If a boot command is not found on the first detected HDD, the system will
not boot from the other HDD. It will search the next device in the boot priority
for a boot command.
■ PC card HDD boot is supported only by the PC card slot on the
computer. Support is guaranteed only for TOSHIBA PC card HDDs.
■ When you assign a PC card HDD top priority, “PC” is not displayed.
However, the PC card HDD takes the position of HDD in the Boot Priority
Options list above.
■ Some modules may not be displayed.