Filter
Top Products
TECRA M2 4-8
Operating Basics
4. Press gently at the center of the CD/DVD until you feel it click into place.
The CD/DVD should lie below the top of the spindle, flush with the
spindle base.
5. Push the center of the drawer to close it. Press gently until it locks into
place.
Closing the DVD-ROM drawer
When the drawer is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the tray. After seating the CD/DVD, however,
make sure it lies flat, as shown in figure above.
■ Do not touch the laser lens. Doing so could cause misalignment.
■ Do not keep foreign matter from entering the drive. Check the back edge
of the tray to make sure it carries no debris before closing the drive.
If the CD/DVD is not seated properly when the drawer is closed, the CD/DVD
might be damaged. Also, the drawer might not open fully when you press
the eject button.