Filter
Top Products
TECRA M2 8-9
Optional Devices
10. Insert a new module in the socket and push it down so it lies flat and is
secured by two latches on either side.
Installing the memory module
11. The keyboard cable is pressed down with Metal brace and one screw
secures the metal brace.
12. Insert tabs on the front of the keyboard into corresponding notches on
the computer and seat the keyboard.
13. Two screws secure the keyboard.
14. Seat the keyboard brace and press to secure latches.
15. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Power-up Modes, for details.
16. Turn the power on and make sure the added memory is recognized.
Open System Properties in the Control Panel and click the General tab.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
When seating the keyboard, be sure to fit the flexible printed circuit board
under the palm rest if the flat cable was pulled out while you were removing
the keyboard.
Be sure to use all two screws removed in step 7. Make sure no screw was
dropped into the computer. Make sure all foreign matter, such as the tape
applied in step 10 is removed.