Filter
Top Products
TECRA M2 7-5
HW Setup
To change the boot drive, follow the steps below.
1. Hold down F12 and boot the computer.
2. The following menu will be displayed with the following icons: Built-in
HDD, Slim Select Bay HDD, CD-ROM, FDD (or SD memory card),
Network (LAN), PC (ATA) card boot.
3. Use the left/right cursor keys to highlight the boot device you want and
press Enter.
■ PC card HDD boot is supported only by slot 0 on the computer. Support
is guaranteed only for TOSHIBA PC card HDDs.
■ When you assign a PC card HDD top priority, “PC” is not displayed.
However, the PC card HDD takes the position of HDD in the Boot Priority
Options list above.
A bar will appear only under the selected device.
■ If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
■ The selection method above does not change the boot priority settings
in HW Setup.
■ If you press a key other than one of those above or if the selected device
is not installed, the system will boot according to the current setting in
HW Setup.
■ Support of PC (ATA) card boot is guaranteed only for TOSHIBA PC card
HDDs
■ A PC (ATA) card takes the position of HDD in the Boot Priority Options
list.