Filter
Top Products
TECRA M2 8-10
Optional Devices
Removing memory module (Main memory)
To remove the memory module, make sure the computer is in boot mode
then:
1. Turn the computer off and remove all cables connected to the computer.
2. Turn the computer upside down and remove the battery pack (refer to
Chapter 6, Power and Power-up Modes.)
3. Follow steps 4 through 9 in Installing memory module to access the
memory module.
4. Push the latches to the outside to release the module. A spring will force
one end of the module up.
5. Grasp the sides of the module and pull it out, then replace the insulator.
Removing the memory module
6. Rotate the keyboard back into place and secure the keyboard brace as
described in the previous section.
7. Turn the computer upside down and replace the battery pack.
■ If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
■ Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
LATCHES