Filter
Top Products
W7 ASD Installation and Operation Manual 119
S1 Terminal
Program Terminal Settings Input Terminals S1 Terminal
Assignment
This parameter selects the functionality of the S1 discrete input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S1 terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138.
Parameter Type — Selection List
Factory Default — Fire Speed
Changeable During Run — No
S10 Terminal
Program Terminal Settings Input Terminals S10 Terminal
Assignment
This parameter selects the functionality of the S10 discrete input terminal.
Note: The S10 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S10 terminal
settings will be stored in volatile memory. The terminal
settings will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S10 terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138.
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
S11 Terminal
Program Terminal Settings Input Terminals S11 Terminal
Assignment
This parameter selects the functionality of the S11 discrete input terminal.
Note: The S11 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S11 terminal
settings will be stored in volatile memory. The terminal
settings will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S11 terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138.
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
S1 Terminal S11 Terminal