Filter
Top Products
46 W7 ASD Installation and Operation Manual
W7 ASD Direct Access/Communication Numbers
The W7 ASD has the ability to allow the user direct access to the motor control functions. The functions
listed below have an associated Parameter Number which accesses its setting. There are three ways in
which the motor-control parameters may be accessed for modification: Program
applicable menu path,
Program
Direct Access applicable parameter number, or via Communications (see the 7-Series
Serial Communications User Manual for further information on communications protocol). Once
accessed, the parameter may be viewed or changed.
The Program mode allows the user to develop an application-specific motor control profile. Motor
control functions may be set to accommodate specific power and timing requirements for a given
application. The configurable parameters of the Program mode that have user-accessible Parameter
Numbers are listed and described below.
Note: The setup procedures included within this section may require a Reset before performing the
procedure. Application-specific settings may then be performed. The pre-Reset conditions may be
saved (see
Save User Parameters).
Table 5. W7 ASD Direct Access/Communication Numbers.
Parameter Name No. Parameter Name No.
Command Mode 0003 Preset Speed #4 0021
Frequency Mode #1 0004 Preset Speed #5 0022
FM Terminal Assignment 0005 Preset Speed #6 0023
FM Terminal Adjustment 0006 Preset Speed #7 0024
Auto Setup for 50 Hz
0007
Low Speed Signal Output Frequency 0100
Auto Setup for 60 Hz Speed Reach Setting Frequency 0101
Restore Factory Defaults Speed Reach Detection Band 0102
Clear Past Trips ST Signal Selection 0103
Clear Run Timer Direction Priority (F and R On) 0105
New Base Drive Board Input Terminal Priority 0106
Save User Parameters ON Terminal Assignment 0110
Restore User Settings F Terminal Assignment 0111
Upgrade Firmware R Terminal Assignment 0112
Set EOI Memory to Default ST Terminal Assignment 0113
Panel Direction 0008 RES Terminal Assignment 0114
Acceleration Time #1 0009 S1 Terminal Assignment 0115
Deceleration Time #1 0010 S2 Terminal Assignment 0116
Maximum Output Frequency 0011 S3 Terminal Assignment 0117
Upper Limit Frequency 0012 S4 Terminal Assignment 0118
Lower Limit Frequency 0013 S5 Terminal Assignment 0119
Base Frequency #1 0014 S6 Terminal Assignment 0120
V/f Pattern 0015 S7 Terminal Assignment 0121
Torque Boost #1 0016 S8 Terminal Assignment 0122
Soft Stall Selection 0017 S9 Terminal Assignment 0123
Preset Speed #1 0018 S10 Terminal Assignment 0124
Preset Speed #2 0019 S11 Terminal Assignment 0125
Preset Speed #3 0020 S12 Terminal Assignment 0126