Filter
Top Products
122 W7 ASD Installation and Operation Manual
S6 Terminal
Program Terminal Settings Input Terminals S6 Terminal
Assignment
This parameter selects the functionality of the S6 discrete input terminal.
Note: The S6 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S6 terminal
settings will be stored in volatile memory. The terminal
settings will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S6 terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138.
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
S7 Terminal
Program Terminal Settings Input Terminals S7 Terminal
Assignment
This parameter selects the functionality of the S7 discrete input terminal.
Note: The S7 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S7 terminal
settings will be stored in volatile memory. The terminal
settings will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S7 terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138.
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
S8 Terminal
Program Terminal Settings Input Terminals S8 Terminal
Assignment
This parameter selects the functionality of the S8 discrete input terminal.
Note: The S8 input terminal may be used without the ASD-
Multicom option board.
Without the ASD-Multicom option board the S8 terminal
settings will be stored in volatile memory. The terminal
settings will be lost if the system is powered down or reset.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S8 terminal to 1 of the 69 possible
functions that are listed in
Table 6 on page 138.
Parameter Type — Selection List
Factory Default — Unassigned
Changeable During Run — No
S6 Terminal S8 Terminal