Filter
Top Products
92 W7 ASD Installation and Operation Manual
OUT7 On Delay
Program Terminal Settings Terminal Delays Output Terminal
Delays
OUT7 On Delay
This parameter delays the response of the OUT7 output contacts by the
programmed value (see waveforms at
FL On Delay).
The delay may be increased to prevent relay chatter.
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
OUT7 Terminal
Program Terminal Settings Output Terminals OUT7 Terminal
Assignment
This parameter sets the functionality of the OUT7 output contacts to 1 of the 58
possible functions that are listed in
Table 7 on page 141.
The on and off delay times of the OUT7 contacts may be adjusted to provide
more response time to the device that is connected to the output terminals.
In addition, the output contacts must be specified as Normally Open or
Normally Closed.
Parameter Type — Selection List
Factory Default — OC Alarm
Changeable During Run — No
Output Phase Loss Detection
Program Protection Settings Output Phase Loss Detection
This parameter Enables/Disables the monitoring of each phase of the 3-phase
output signal (U, V, or W) of the ASD. If either line is missing, inactive, or not
of the specified level, the ASD incurs a trip.
Parameter Type — Selection List
Factory Default — Disabled
Changeable During Run — No
Output Short Circuit Test
Program Protection Settings Output Short Circuit Test
This parameter determines when the system will perform an Output Short
Circuit test.
Settings:
First Time (each startup from off or reset)
Standard (each startup)
Parameter Type — Selection List
Factory Default — Standard
Changeable During Run — No
Output Short Circuit Test Duration
Program Protection Settings Output Short Circuit Test Duration
This parameter sets the pulse width of the ASD output pulse that is applied to
the motor during an Output Short Circuit test.
Parameter Type — Numerical
Factory Default — (ASD-dependent)
Changeable During Run — No
Minimum — 1
Maximum — 100
Units — µS
OUT7 On Delay Output Short Circuit Test Duration