Filter
Top Products
W7 ASD Installation and Operation Manual 133
Units for Voltage and Current
Program Utilities Display Attributes Units for Voltage and
Current
This parameter sets the unit of measurement for current and voltage values
displayed on the keypad.
Settings:
%
V/A
Parameter Type — Selection List
Factory Default — %
Changeable During Run — Yes
Upper Deviation Limit
Program Feedback Settings Upper Deviation Limit
This parameter determines the maximum amount that the feedback may
increase the output signal.
Parameter Type — Numerical
Factory Default — 50.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 50.00
Units — %
Upper Limit Frequency
Program Fundamental Parameters Fundamental #1 Upper
Limit Frequency
This parameter sets the highest frequency that the ASD will accept as a
frequency command or frequency setpoint. The ASD may output frequencies
higher than the Upper Limit Frequency (but, lower than the Maximum
Frequency) when operating in the PID Control mode, Torque Control mode,
or the Vector Control modes (sensorless or feedback).
Note: This setting may not be higher than the Maximum
Frequency setting.
Parameter Type — Numerical
Factory Default — 60.0
Changeable During Run — Yes
Minimum — 0.0
Maximum — Max. Freq.
Units — Hz
User Unit #1
Program Utilities Display Attributes User Unit #1
The displayed unit of measurement may be changed from the Hz default setting
to any of the available characters for the frequency-display screen.
User Unit #2 – #5 may be used to complete the unit of measurement display.
Note: Program Utilitites Display Attributes Hz Per User-
defined Unit must be a non-zero value to use this feature.
Parameter Type — Alpha-Numeric
Factory Default — 0.00
Changeable During Run — Yes
User Unit #2 – 5
Program Utilities Display Attributes User Unit #2 – #5
See User Unit #1 for information on this parameter.
Units for Voltage and Current User Unit #2 – 5