Filter
Top Products
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
E-6 XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE
Note: The WS parameter CL specifies that datasets with the
same class as the WS parameter should be selected. D
specifies that only datasets with the same destination as the
DGROUP parameter should be selected. F specifies that JES3
DGROUP None Installation
printer
destination
naming
conventions
1 to 8-character
alphanumeric
string
Specifies destination
processed by this FSA
(applicable only if D is
specified in the WS
parameter).
DTYPE None PRTAFP1 PRTAFP1 Required parameter
DYNAMIC NO Installation
printer name
standards
YES or NO DYNAMIC=NO should be
specified so JES3 will
keep FSA active between
transmission of datasets.
FSSNAME None Name of FSA in
JNAME
parameter
1 to 8-character
alphanumeric
string
Must match value in
FSSNAME parameter of
FSSDEF statement.
JNAME None FSSNAME
parameter of
FSSDEF
statement
1 to 8-character
alphanumeric
string
Must match value in
FSSNAME parameter of
FSSDEF statement.
JUNIT ON See comments. (Device address,
Main, dest class,
ON/OFF)
Device address should not
be specified for TCP/IP
printers.
Main is name of processor
the FSS is to run on.
Dest class is destination
class for FSA messages.
ON or OFF specifies
whether FSA is initially
online or offline.
MODE None Must be FSS. FSS MODE=FSS must be
specified.
WC Any class
selected
Installation
output class
standards
List of
alphanumeric
output classes,
each separated
by a comma
If CLASS is specified in
the Work-selection
criterion in the WS
parameter, the FSA
selects datasets that
match values specified
here.
WS Installation
preferences (see
note)
Work-selection
criterion
Consider CL, R, and F.
See Note below and JES3
Initialization and Tuning
Reference manual for
more information.
Table E-3. JES3 FSS statement parameters (continued)
Item
description Default Source of value
Range of
acceptable
values Comments Your value