Filter
Top Products
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
E-20 XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE
3. Create the printer device description – AS/400
Follow these steps to create the device description for the IPS
printer.
1. At the AS/400, press <F4> to prompt the CRTDEVPRT
command.
2. Key in the parameter values as indicated in the appropriate
figure below.
• Table E-16 shows printer description parameters for OS/
400 with V3R7 installed.
• Table E-17 shows parameters for OS/400 with V3R2
installed.
For parameters with * beside them, refer to the
configuration worksheet, earlier in this section.
Table E-15. Create PSF Configuration screen – AS/400
Create PSF Configuration (CRTPSFCFG)
Type choices, press Enter.
PSF configuration......... > XEROXIPS *
Library................. > QGPL
User resource library list. *JOBLIBL
Device resource library list....
+ for more values
*DFT
IIPDS pass through....... *NO
Activate release time..... *NORDYF
Release time............. > *SEC15
Restart timer............ > *IMMED
SNA retry count.......... 2
Delay time between SNA retries.. 0
Text ‘description’........ *BLANK
Additional parameters....
Blank page............... *YES
Page size control........ *NO
Resident font............ *NO
Resource retention....... *YES
Edge orient.............. *NO
Remote location:
Name or address........ > ‘9.9.999.999’ *
TCP/IP port.............. > 5001 *
TCP/IP activation timer... 170