Filter
Top Products
PRINTER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE 6-5
Space requirements
You should consider the following factors when deciding where to
place the printer hardware components:
• Adequate work space and service clearance around the
equipment
• Proximity to electrical and network connectors
• Security of the work area. You may need to place the system in
an area where you can restrict access to it. This may be
important if your personnel need to print confidential documents
or if you are concerned with unauthorized usage.
Dimensions and weights of the printer components are listed in this
section, along with diagrams, to help you visualize the sizes and total
space requirements.
!
Warning: The printer controller must be positioned within the line-
of-sight of the printer for safety purposes while servicing the
equipment.
Note: There must be a 78-inch / 198-cm vertical clearance
throughout the entire area. In addition, your printer must be installed
in a fixed location with a minimum clearance space of 36 inches /
91.4 cm around all sides of each piece of equipment for access by
service personnel.
For information on clearance space and other space planning
considerations, refer to the “Space planning guidelines” section of
this chapter. Contact your service representative if you have
questions not specifically addressed in this guide.
Printer placement
The following configurations are available for your Xerox DocuPrint
4850/4890 printer:
• Standard (two-tray) feeder with dual stacker
• Standard (two-tray) feeder with stitcher/stacker
• High-capacity feeder (HCF) with dual stacker
• HCF with stitcher/stacker.
Note: Additional space (6-inch by 64-inch / 15 cm by 163 cm) is
required in front of the printer for CCU changeout cart
operability.
!