Filter
Top Products
PRINTER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE 6-11
Space planning guidelines
When determining your space requirements and planning for shared
space between your DocuPrint printers, it is important to consider all
of the components you plan to install.
To ensure all of the space requirements are met, it is important to
work with your Xerox representative.
Before installation, you must consider the following:
• Clearance space requirements where you intend to install the
printing system
• Delivery access requirements
• Recommended cable lengths and locations (refer to the
“System connections” chapter of this guide for more
information)
• Floor leveling.
Clearance space requirements
The printer must be installed in a fixed location that provides the
following clearance space:
• 36 inches / 91.4 cm on all sides of each component
• 78 inches / 198 cm of vertical clearance throughout the entire
area
• 24 inches / 61 cm of exclusive operator area in front of each
component.
Shared space
It is best to provide the full amount of clearance space around the
hardware components. Your environment may require you to use
shared space between components, such as between the printer and
another Xerox printing system. You can share the 36-inch / 91.4 cm
clearance space around each component, as long as you follow
these rules:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch / 91.4 cm general service
clearance areas, but they may not share the 24-inch / 61 cm
operator area in front of each component.
• There must be 78 inches / 198 cm of vertical clearance
throughout the entire area.
Note: Finishers attached to your bypass transport may occupy
shared space with Xerox equipment. However, they must be
removable to allow servicing of the DocuPrint NPS printer stackers.
Consult with your Xerox representatives to ensure all the
requirements are met.