Filter
Top Products
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE E-29
Configuration steps – OS/2
This section describes the process for configuring a TCP/IP attached
host computer with OS/2 to print on an IPDS printer such as your IPS.
Configuration worksheet The following worksheet will help you in planning the IPS installation.
It describes the key values which you need to supply when planning
the OS/2 configuration. All values on this worksheet must be
determined before you begin the printer configuration on the host.
1. Configure the printer for TCP/IP in OS/2
Configure your IPS for TCP/IP. (Refer to your IPS Guide to
Configuring and Managing the System, chapter 4, “Setting up the
Printer Controller.”
2. Provide TCP/IP routing information if necessary
TCP/IP routing information is needed for remote LAN configurations
only. (Refer to your host computer documentation for procedures, if
needed.)
Table E-23. OS/2 configuration worksheet for IPS
Item description Also known as... Source Your value
Device Name PSF/2 Control Panel—Define Device
Device Description PSF/2 Control Panel—Define Device
Device Resolution DPI, Pels per inch PSF/2 Control Panel—Define Device
Attachment Type Printer Protocol PSF/2 Control Panel—Define Device TCP/IP
IP Address TCP/IP Address
IPADDR
Xerox NPS Printer software installation.
PSF/2 Control Panel—Attachment Type
Settings
TCP/IP Port Number PORTNO IPS configuration Interface window and
subwindows
PSF/2 Control Panel—Attachment Type
Settings
Connect Timeout Device Busy Time PSF/2 Control Panel—Define Device
Max Transmission Unit MTU
Max packet size
MAXMTU
OS/2 TCP/IP Configuration (TCPIPCFG)
Xerox NPS printer installation
Queue Name PSF/2 Control Panel—Define Queue
Queue Description OS/2 Printer
Queue Name
PSF/2 Control Panel—Define Device
Device Busy Time
(Optional)
Connect time-out PSF/2 Control Panel—Printer Definition