Filter
Top Products
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE 5-9
Controller hardware specifications and requirements summary
The following table summarizes the specifications and electrical
requirements of your DocuPrint IPS printer controller hardware
components.
For a summary of printer hardware specifications and requirements,
refer to the “Printer specifications and requirements” chapter of this
guide. Contact your service representative if you have questions not
specifically addressed in this guide.
Table 5-4. 4850/4890 IPS printer controller specifications and
power requirements
Device
Dimensions (depth,
width, height) Weight
Heat
dissipation Power requirements Cable lengths
Host Channel
Unit (HCU)
(channel-
attached
systems only)
d=15 in. / 40.8 cm
h=5 in. / 12.6 cm
w= 16 in. / 41.6 cm
26 lbs. 10
oz. / 12.4
kgs
N/A 120 VAC within 6 feet;
120 volt at 2 amps or
240 volt at 1 amp
Bus and tag
cables must
conform to host
system
requirements
(200 to 400 ft. /
66.7 to 133.3 m)
and
accommodate
system setup.
Processor d=16.1 in. / 40.9 cm
w=16.4 in. / 41.7 cm
h= 3 in. / 7.6 cm
27 lbs. /
12.7 kgs
1,100 BTU
per hours
Sun Ultra 2 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
Sun Ultra 2 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
Sun Ultra 60 (60 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA,
5-15 NEMA
Sun Ultra 60 (50 Hz):
100 to 240 VAC,
15 amp, 0.4 KVA
Power: 8 ft. /
2.4 m
Interface to
printer:
20 ft. / 6.1 m
usable length
Monitor d=6.1 in. / 41cm
w=20 in. / 50.8 cm
h=17.7 in. / 45 cm
61 lbs. /
27.7 kg
408 BTU
per hour
100-120 ~ VAC,
1 phase, 50-60 Hz,
3.0 amp, 0.4 KVA
200-240 ~ VAC,
1 phase, 50-60 Hz,
2.0 amp, 0.4 KVA
Video cable to
processor:
46 in. / 1.17 m
4 mm cartridge
tape drive
d=12.2 in. / 31 cm
w=7.5 in. / 19 cm
h=2.8 in. / 7 cm
8 lbs. /
6.6 kg
--- 100-120/200-240 VAC,
0.8/0.4 amp, 47-63 Hz
SCSI cable to
processor or
additional SCSI
device:
28 in. / 71 cm