Filter
Top Products
PRODUCT OVERVIEW
1-4 XEROX DOCUPRINT 4850/4890 IPS INSTALLATION PLANNING GUIDE
Jobs can also be printed on special stocks such as labels and
transparencies.
The printer engine monitors the print job so that, should a paper
jam occur, the job resumes on the correct page, providing
complete document integrity.
• 300 dpi resolution — The 4850 and 4890 IPS provide high
print quality at 300 dpi resolution. They can receive data at 240
or 300 dpi; 240 data is converted to 300 by the controller.
The IPS must be configured to the same font resolution as the
host input data stream (refer to your 4850/4890 IPS Guide to
Configuring and Managing the System for instructions on
configuring for the correct input resolution). Conflicts between
the input font resolution and the IPS configuration could result
in inability to print the job, or in variable data missing from the
output.
Note: You will normally achieve better print quality by
converting all 240 dpi fonts and other resources to 300 dpi
before printing, rather than leaving the conversion for the
controller to do. However, you should always run test prints to
validate your particular applications.
• Bypass transport option (4890 IPS only) — The bypass
transport enables sheets to pass through the printer output
module to a third-party finishing device. With such a device, you
add to your 4890 IPS such finishing capabilities as saddle-
stitching, binding, trimming, etc. The bypass transport fits into
tray 1 of the dual stacker, and can be easily removed and
installed by the operator. (For further information on this option,
refer to the “Bypass transport specifications” appendix of this
guide.)
• Sixth Sense Remote Service — The Xerox Sixth Sense
Remote Service feature allows Xerox support personnel to
access IPS/NPS controller via modem from a remote location.
More information about Remote Service can be found in the
Xerox DocuPrint 4850/4890 IPS Troubleshooting Guide.
• Choice of dual or stitcher stacker — Your 4850/4890 IPS is
available with one of two stacker types: a dual stacker, with two
output trays, or a stitcher/stacker which can place a wire stitch
in sets of up to 50 sheets.
Output tray capacities, based on 20-pound or 80 gsm stock,
are:
— Dual stacker trays 1 and 2: 750 sheets each
— Stitcher/stacker: 2000 sheets.